Toyota Tundra Roof Racks

New in 2023, we also offer our same style of rack for the Toyota Tundra platform. These racks are similar to the Tacoma double cab, but sized specifically to fit Toyota Tundras. Unlike the Tacoma, there are no threaded holes in the roof from the factory, so drilling is required to install these racks, usually a combination of tapped threads and riv nuts. To see more about this process, take a look at the 4Runner installation video, found on the 4Runner racks page.

Note there are different body styles for the generation of Tundra, so when you receive your rack quote be sure to also specify which year Tundra you have, and better yet match that to one of the images in the galleries below.

pricing

Flat racks are $975. Full Expo racks with side handles, choice of wind fairing, and side gussets are $1245. All racks come with powder coating, towers, all of the hardware you need to attach the rack to the vehicle, and the rack to the towers. You will need to add your own threaded holes to your roof channel to complete the install, and provide your own riv nuts if using them. Installation help is available in Denver, Co., for shipping figure about $375 send your address for a shipping quote, and/or email us for a drawing and quote to sales@gamiviti.com

First Gen Tundra Double Cab

Can use both Slim and Traditional fairing shapes

Compatible with all Gamiviti rack accessories

Available both Expo up & Expo down (shown)

Additional welded options also available

The rack above was custom sized to fit the 1st gen Tundra double cab. Flat rack dimensions are 52.75” wide x 59” long.

second gen tundra doublecab

Available with either fairing style

Sized to fit Doublecab models

Ample room for gear

Compatible with all Gamiviti rack accessories

Second Gen Tundra Crew MAX Cab

Towers added to roof channel

Tower locations

Easily add additional accessories

Optional light bar tabs

Multiple fairing options

Low profile, multiple uses

installation videos

installation hole spacing

To install you’ll need to add threaded holes to your roof channel, as mentioned above. You can see this process in the 4Runner install video, the process is essentially the same. https://www.gamiviti.com/4runner-racks. To determine the hole location, you basically have 2 options…

Install the towers to the rack, remove the roof channel cover from both sides, the gently position the rack onto the truck. Dial in the location, tower height, tower positions, etc. then use a marker to mark your locations for holes. Remove the rack, add the holes, install the rack.
Add the threaded holes to your roof first, using the hole template below. Measure your first hole from the very top corner of the windshield, into the roof channel. Every tower requires 2 holes 3” apart.

Our recommendation would be option 1, as you will have a little more freedom for exactly where the rack starts over the windshield, and where the rack ends at the back edge of the cab. But the above numbers are exactly what we used on our Tundra CrewMax install.